First Look Felt Decree

Return to article
The “Flip Chips,” located on the inside of the Decree’s seat stay links, allow riders to switch the bike’s geometry between “low and slack” and “steep and high.” All that’s needed to make the switch is a hex wrench. However, Felt recommends doing it with the bike on a stand because a bit of pressure is required to flex the seat stays to remove and install the shock bolt.

Felt Decree

The “Flip Chips,” located on the inside of the Decree’s seat stay links, allow riders to switch the bike’s geometry between “low and slack” and “steep and high.” All that’s needed to make the switch is a hex wrench. However, Felt recommends doing it with the bike on a stand because a bit of pressure is required to flex the seat stays to remove and install the shock bolt.


NOTE: There are two ways to comment on our articles: Facebook or Wordpress. Facebook uses your real name and can be posted on your wall while Wordpress uses our login system. Feel free to use either one.

Facebook Comments:



Leave a Reply

Your email address will not be published. Required fields are marked *

*
*

THE SITE

ABOUT MTBR

VISIT US AT

mtbr.com and the ConsumerReview Network are business units of Invenda Corporation

(C) Copyright 1996-2018. All Rights Reserved.